Deer Hunting Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I test fired my vortek about 2 wks ago to make sure it was ready to go. Everything was fine. Now after loading up I find the hammer will not go forward far enough to strike the firing pin. I took the trigger assembly out and everything looks fine but it still will not go forward enough to strike the pin. Any suggestions? Thanks:confused:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top