Deer Hunting Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
75 Posts
Beaux, you say you work on your own bow,heres a tip you might try if you dont already know it. Take a bolt that is about 4 inches long and screw it into your stabilizer hole and then take an allen wrench that fits the limb pocket bolt and cut the long end so when inserted into the bolt the short end sits closer to the bow make sure the small end is turned up as straight as possible without turning the bolt.Now take a large rubber band and hook it on the allen wrench,then stretch it and hook it to the bolt coming from the stabilizer hole,now nock an arrow and with the shaft sitting on the rest and inbetween the rubberband you can measure the distance between each side of the shaft and the rubberband.Now read the hole in your paper and should only have to adjust for nock high or nock low.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top