Deer Hunting Forums banner
1 - 11 of 11 Posts

·
Registered
Joined
·
90 Posts
Discussion Starter · #1 ·
Along with being new to this site I am also new to using powder in place of pellets... I have yet to pour a load and don't really know how to go about it. I hope this does not seem like a stupid question because I like to do things right the first time, so any input would be appreciated.

I do have BH 209, shotgun primers, and .50 powerbelts. I did purchase a plastic measurer that I would pour the powder in to get my 100gr. of powder but is there anything else I need to properly pour the powder?
 

·
Registered
Joined
·
3,271 Posts
Hey there's no stupid questions on here, unless I'm the one asking. Sorry I can't help ya,, not a big ML hunter!
 

·
Registered
Joined
·
180 Posts
Along with being new to this site I am also new to using powder in place of pellets... I have yet to pour a load and don't really know how to go about it. I hope this does not seem like a stupid question because I like to do things right the first time, so any input would be appreciated.

I do have BH 209, shotgun primers, and .50 powerbelts. I did purchase a plastic measurer that I would pour the powder in to get my 100gr. of powder but is there anything else I need to properly pour the powder?
It sounds like you're doing it ok.

Are you getting good ignition with no delays or misfires? The BH 209 needs a hot 209 primer to be consistent. I like the CCI magnum primers.
 

·
Registered
Joined
·
8,459 Posts
Black Horn powder is my in-line ml favorite. You may want to experiment with several bullets/brands and see what shoots the best. You may find too that with a particular bullet that going down or slightly up on the charge will give you better bullet groups. Just learn to seat the bullet firmly on the powder charge each time without smashing it hard and remember when you get your final combination, make a mark on your ram rod to indicate proper seating position and that way you'll always know if you've errored in your loading before a potential really bad thing could happen. I like CCI prmers and TC & Barnes bullets. Good luck and enjoy!
 

·
Registered
Joined
·
90 Posts
Discussion Starter · #5 ·
Ever since I bought the powder the weather here has been lousy for muzzleloaders, raining in WNY... my brother says just get out and shoot, but i don't think powder and rain are a good combo:thumbdown:

As far as pellets are concerned the Acurra shoots them well other then the soot at the firing pin, and FG has steered me what to do in that respect... just waiting till the weather breaks and I will be at the range.
Thanks for the input gents:thumbup:
 

·
Banned
Joined
·
611 Posts
blackhorn wont absorb moisture from the air, it has a special coating on it. Dump some into a little bowl of water, drain the water and then pour the powder onto a dry paper towel and let the powder dry, once its dry you can reuse it.
 

·
Registered
Joined
·
8,459 Posts
rain/snow and flintlocks don't mix well, actually they mix very well all the way to soup. black powder really absorbs moisture. Last two hunts in PA late season were really bad on the flintlocks as it was snowing really hard. We didn't prime the pans as were hunting and the main charges still got wet. I've tried everything known to man but sometimes it just a pain in the rump using the flintlocks. I still wonder how they fought wars using them?? Didn't fight in the rain I guess??
 

·
Registered
Joined
·
90 Posts
Discussion Starter · #11 ·
Yea Hunt man, they must have had "fair weather" battles. lol
Daddus, I already feel welcome to the site:thumbup: Thank you.
 
1 - 11 of 11 Posts
Top