[ldcattle]

Anyone know how to tighten the buttstock to the receiver on a Knight Revolution II? I just noticed mine has a slight (1/16th") twist to it.

I took the trigger assembly out, however there are no obvious screw heads to tighten.

Is this an issue? Can it still be used?

Thanks

 

[timetohunt]

I cant tell you off hand but I will take a look at mine after work and get back to you. Its definitely usable and not broke though so dont worry about it.

 

[ldcattle]

Found it. Located under the recoil pad. Requires a 12" long hex head.

Thanks anyway

 

[Guru]

Knight Revolution

I know this thread is almost a year old, but how did you remove the recoil pad without damaging it. I have the 1st gen Revolution and my stock just started to loosen up. Thanks.

 

[timetohunt]

I can check on this for you although mine in the Rev II

 

[Guest]

How do you get the recoil pad off of a ravolution 2.

 

[frontiergander]

be sure to check out the knight recall on the revolution. They have a recall out for the trigger.