Deer Hunting Forums banner
1 - 4 of 4 Posts

· Super Moderator
Joined
·
8,472 Posts
Discussion Starter · #1 ·
Nearly cut two fingers off with the table saw today. Lucky just some lost meat. I've never had an accident like this in all the years running power equipment. Please be carefull everyone and remember where your fingers are at all times. I had shut the saw off and as it was slowing down I set a board next to the blade with my fingers in front of the board and outch!:bag:
 

· Premium Member
Joined
·
5,420 Posts
That stinks.. I was putting side gates back on a trailer the other day.. (these weigh about 150lbs a piece) And like a moron had my hand on the bottom side of it when the gate slid down into place.. Hurt and swelled like crazy but luckily it smashed it in probably the only place it would be hard to break.. The first bend on the tips of your fingers..
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top