Deer Hunting Forums

Deer Hunting Forums (http://www.deerhuntersclub.com/forums/)
-   Rifle Hunting (http://www.deerhuntersclub.com/forums/rifle-hunting/)
-   -   M70 7mm Rem Mag (http://www.deerhuntersclub.com/forums/rifle-hunting/8387-m70-7mm-rem-mag.html)

gawith0413 10-11-2011 01:49 PM

M70 7mm Rem Mag
 
What ammo would you use for whitetail deer hunting. I want something that will fly straight and not damage the meat too bad. Please factory loads for the time being.

Karl.Luhr 10-11-2011 03:42 PM

Light for caliber bullets are a bad idea..
 
Everyone has had different experiance in bullet performance. A lot of shooters that use the 30-06 like 150gr bullets. To me that is a little light, I always shoot 165gr Ballistic Tips or 165/180gr Partitions and have never had a issue with bullet performance after it hits the animal. If it was my new 7mm mag I would load up some with both 150gr and 160gr bullets. I would think that the 160gr bullet weight in a controlled exp type would be the choice for Elk.

Karl

rdrader2002 10-11-2011 07:45 PM

"I want something that will fly straight and not damage the meat too bad."

Good shot placement (aka double lung??) and you're not going to damage any meat.

Best suggestion is to try several makes/grains to see what shoots best through your rifle.
Don't have a 7mm Mag so can't make any more/better/gooder suggestions.

RR

rack collector 10-11-2011 07:59 PM

In my 7mm mag I found that 140 grain bullets were the most accurate with the 165 grain running close second. Both of them were in a Federal Premium. I never had a 150 grain bullet shoot very good in my rifle. Before I started handloading I was shooting a Hornady Custom 139 grain BTSP. These shot as accurate and performed as well and they didn't cost as much as the Federals. Good Luck.

gawith0413 10-13-2011 02:50 PM

Any more suggestions?

kemster99 10-13-2011 04:53 PM

Range time.. with a new rifle i will buy a couple boxes of shell from different manufactuers in different bullet weights. Then i shoot what the rifle will group the best.

Karl.Luhr 10-13-2011 05:54 PM

Break-in that new barrel slowly
 
With any new rifle you are going to want to shoot a bunch of ammo through it. Try to be gental with the first couple of boxes. I try to break-in my new barrels with lots of cleaning between groups. This also slows me down and the barrel never gets hot.

Karl


All times are GMT -5. The time now is 10:21 PM.



LinkBacks Enabled by vBSEO 3.0.0 RC8