Deer Hunting Forums

Deer Hunting Forums (http://www.deerhuntersclub.com/forums/)
-   MuzzleLoader Hunting (http://www.deerhuntersclub.com/forums/muzzleloader-hunting/)
-   -   Knight Revolution II question... (http://www.deerhuntersclub.com/forums/muzzleloader-hunting/8698-knight-revolution-ii-question.html)

ldcattle 11-16-2011 08:56 AM
Knight Revolution II question...
 
Anyone know how to tighten the buttstock to the receiver on a Knight Revolution II? I just noticed mine has a slight (1/16th") twist to it.

I took the trigger assembly out, however there are no obvious screw heads to tighten.

Is this an issue? Can it still be used?

Thanks

timetohunt 11-16-2011 10:11 AM
I cant tell you off hand but I will take a look at mine after work and get back to you. Its definitely usable and not broke though so dont worry about it.

ldcattle 11-16-2011 10:31 AM
Found it. Located under the recoil pad. Requires a 12" long hex head.

Thanks anyway

Guru 10-18-2012 07:38 PM
Knight Revolution
 
I know this thread is almost a year old, but how did you remove the recoil pad without damaging it. I have the 1st gen Revolution and my stock just started to loosen up. Thanks.

timetohunt 10-19-2012 09:27 AM
I can check on this for you although mine in the Rev II

Unregistered 11-16-2012 04:04 PM
How do you get the recoil pad off of a ravolution 2.

frontiergander 11-16-2012 10:36 PM
be sure to check out the knight recall on the revolution. They have a recall out for the trigger.


All times are GMT -5. The time now is 12:19 PM.



LinkBacks Enabled by vBSEO 3.0.0 RC8